420 Posts in 208 Topics by 63 members
Statics
If this is your first visit, you will need to register before you can post. However, you can browse all messages below.
Moderators: Andy Juniper , Guy Maslen , Keleigh Jones
| Page: 1 | Go to End | |
| Author | Topic: About Resstat module | 490 Views |
About Resstat module 
12 June 2018 at 8:23pm
Hi,
I would like to know if the resstat module is based on the same articles than the spstat module.
Especially the J.Ronen&J.Claerbout 's article.
Thank you in advance,
Matt.
Re: About Resstat module
13 June 2018 at 2:09pm Last edited: 13 June 2018 2:09pm
RESSTAT ia a CDP-aligned residual statics module while SPSTAT is a stack power residual statics module.
SPSTAT2 is a replacement for SPSTAT introduced in the V6.8 beta releases; it retains or improves on the functionality of the older module, but is much easier to use.
The RESSTAT module is not based on the same articles listed in the SPSTAT module's help documentation.
Re: About Resstat module
14 June 2018 at 3:45am
Ok, thank you the precision !
Is it possible to have the articles on which you based the resstat module ?
Thank you for your answer.
Re: About Resstat module
14 June 2018 at 2:08pm
We don't have any article references for the RESSTAT module, it just follows the generic CDP-aligned residual statics methodology.
Seismic Data Analysis by Öz Yilmaz, the residual statics corrections section, might be a good reference source.
| 490 Views | ||
| Go to Top |